[shiftinraptors]

I took my carb apart and cut the 5 rins off of the spring in there. Where are these 2 holes to drill out 1/32 size bigger? Under the brass cap which is held on by 2 screws or the bottom plate that is now held on by 4 allen bolts??? Where in these locations are they at?? Just wondering, I must be blind.

Brian

 

[njripper]

the are on the slide. Remove the round cap, pull out the spring and slide. Look at the bottom of the slide where the needle sticks out and there is a hole on each side of the needle. These are the holes to drill. I believe the bit size is 1/8".

 

[robg]

What is the purpose of drilling these out?

Rob

 

[shiftinraptors]

what I've read is that if you cut the spring, it allows something to open easier and if you drill out these two holes, after you cut the spring, it allows more air to flow easier and revs quicker. Some people have done it. Thanks

Brian

 

[vortec57]

i cut my spring and drilled the holes, now it raps so fast its almost hard to shift quick enough, i just need a pipe and maybe a rev box,, cant wait to go home and race my friends way modded craptor and smoke him by even farther

 

[shiftinraptors]

I cut the spring, drilled the holes and really can't tell much of a difference. Maybe a slight bit, but not really. Not much of a mod if you ask me.

Brian