[dudenhymer]

well the first time I decided to change the needle position on my carb I took the slide out, pushed the needle up and the contents of the needle area all popped out of the top. I'm not sure I found it all but this is what I have... Needle, white spacer below the clip, then white plug the sticks above where the needle sits. with everything together the way I have it, there is some play in the needle, meaning it can move up and down just a little, not tight. WHen I put everything together it runs great. What do you guys think? Is the play in the needle causing any problems or hindering performance at all?? What am I missing? Have any of you removed spacers from your needle? Do you use the white spacer? How are you set up?

THanks a ton for your help,
Sean

 

[jweese]

No. This is what you should have. There is a stainless washer, white spacer, e-clip, gold washer, gold spring, grey top and of course the needle. Good luck!

 

[bassman]

I have my slide out, now how do I remove the needle?

 

[bassman]

I figured it out. its supposed to be on the 3rd clip right? while I was there checking it I cut 5 rings off of my spring and drilled out the two holes. I am hoping to get a little more performance out of this piece of crap carb. I couldnt believe it when I removed the slide and it was made of plastic!!