Polaris Riders Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I'm sorry if this has been mentioned before. I need a walk through of sorts on how to change the bearings in the the pro steering idler arms. There's a top and bottom bearing with a spacer in between on each idler. I can't figure out how to get them out. I've got the steering box off wheeler. Does it require special tool? Blind hole bearing puller maybe? If so harbor freight has them. Also the bottom bearing where the steering stem goes in. Can you pound it out or does that require something special. I got the snap ring off but don't dare to just pound on it. Any help by anyone would be appreciated. Thanks
 
1 - 1 of 1 Posts
Top