[predatorracer]

can some one give me the dimensions of the radiator scoops for the predator and the angle that they are set at i want to make some out of diamond plate

 

[marlboro80]

just make your own design! diamond plate should look awsome

 

[rpm9001]

I would like someone to post the same thing...Let's seee them..I will post mine when Im done. working on them now, just logged on to see if anyone posted there dimensions

 

[vortec57]

just make some at the size you want, about a 30 - 35 degree angle i think is what i used on mine. though i dont reccomend diamond plate for radiator scoops, its thicker and heavier than what you need might have troubles with it stressing on your radiator too much. but thats just me talking.

 

[rpm9001]

I was just going to ask what was a good angle...I eyeballed it and its close to that. Goinf to use some thin alum..
Has anyone had troubles with there rad's after they installed there scoops?

 

[1]

I would think bigger is better, Hardrock & modquad makes them,(PLUG) But the angle of them, well are you going to tie them back into the frame (ect) then you can make them bigger. Also remenber, (force) does'nt come into play,(just drag) well most times. Till you hit 80mph. IMO Short times are no-prob-lem-o
I have a few tricks that I have done to mine. No pics at this time.

later