Polaris Riders Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
455 Posts
Discussion Starter #1
Besides using a spanner wrench, what else could I use to turn the do hicky on the axle that loosens/tightens the chain?

Thanks.
 

·
Registered
Joined
·
217 Posts
I just did this myself yesterday. I used a large, flat head screw driver, i slide the screw driver through one of the holes between the sprocket and sprocket hub and then into one of the slots of the axle/bearing carrier(the do hicky). I just held it tight in the slot and turned the wheels. as the sprocket turned so did the carrier. This is hard to describe with words. its just easier to show but i don;t have that luxury on a forum.
 

·
Premium Member
Joined
·
383 Posts
I did it the same way Local did. It was a pain because you have to try to do multiple things at once. I was afraid that I did it wrong but it is still adjusted right.
 

·
Registered
Joined
·
455 Posts
Discussion Starter #5
Thanks for the tip. It worked quite well. A little note, that chain rattle is starting to get on my nerves. Its gotten ALOT better since I tightened up the chain, but I still find it aggravating. :/
 
1 - 5 of 5 Posts
Top