Polaris Riders Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi i have a problem with my carrier bearings. I just ordered new, installed them and there was a little play not to much. I thought it might be normal so i went out and played... after coming back and lifting the rear the bearing seals have popped out of the carrier and there is about 1 inch of side ways movement. I have made sure its tight, as tight as i can get it.... all the parts are here according to the schematic i looked at. Im kinda stumped and thinking about getting a whole new swing arm, axle carrier set up lol

anyone know how to remedy the slop in the bearings?

thanks for the help

peace for now
 

·
Registered
Joined
·
5 Posts
Discussion Starter #2
I must have found a dead forum, that sucks lol

anyway Im ASSUMING there is a difference in bearing size between the 03 and the 04 on models ...... Im ASSUMING thats where the play is coming from. What else could it be? All the parts are present.

Thanks for all the warm welcomes lol
 
1 - 2 of 2 Posts
Top